Skip to main content

Lift Controller

Central Unit DAVID 613 ZR

High flexible elevator controller for rope and hydraulic systems up to 64 stops. Electable are one-and two-button collecting controllers, and other control-types. All inputs and outputs are free programmable with more than 1600 input- and output functions.

There is a group concept with up to 8 lifts. Full casing central processing unit in an aluminum housing with integrated power supply, and auxiliary power source. Decentralized control concept with bus systems to the cab, to the shaft and to the control Energy efficient according to VDI 4707. Compliant with EN81-20. CANOpen compatible.

Car Processor Unit 613 FKR

The Lift control system DAVID-613 is a distributed control system.

The information is serially transmitted from the central unit to the car controller unit FKR.

In the figure on the left of the box with complete inspection is FKR (middle right), terminal block X11 (below), power outlet, power supply and alarm horn.

The FKR coordinates the shaft copy, load measurement, cabin-gong, and door control. Up to three inside panels, as well as matrix, LCD and TFT displays can be connected.

Handheld-Unit HPG-60

The mobile programming unit HPG-60 allows the parameterization and implementation of diagnostic functions. This can control, as well as the frequency converter or the soft start unit SAG-90, as well as serve and parameterization by the HPG-60, all parameters can be displayed and changed.

REMOTE STATION ER-2014

The remote station ER-2014 provides 16 inputs and outputs, including 6 free inputs and outputs. There are 2 pieco-outputs for the call messaging of bus-matrix-indicator.

The remote station have all necessary call-channels and arrow-outputs (even for selective door-controlling). For group are operating according 4 outputs for displaying car position and 2 arrows per elevator. In addition, there are 2 Outputs for landing operation and special trip per elevator.

The lower 7-pin plug with the call-messaging 2xA & 2xB is responsible for the Door 1, the upper plug with 2xC & 2xD for the Door 2.

The matrix-indicator with RJ-12 cable are to put in the 2 black jacks

The yellow marked RJ-12 jack for high-quality TFT graphic displays with KW-bus connection.

REMOTE STATION ER-2013

The remote station ER-2013 provides 8 inputs and outputs, including 6 free inputs and outputs. There are 2 pieco-outputs for the call messaging of bus-matrix-indicator.

The remote station have all necessary call-channels and arrow-outputs (even for selective door-controlling)

The lower 7-pin plug with the call-messaging 2xA & 2xB is responsible for the Door 1, the upper plug with 2xC & 2xD for the Door 2.

The matrix-indicator with RJ-12 cable are to put in the 2 black jacks.

The yellow marked RJ-12 jack for high-quality TFT graphic displays with KW-bus connection.

HANGING WIRE EHK40 & EHK48

The Hanging wire EHK40 is the physical connection between the central-unit-controller and the car-controller. You can use it for elevators with 64 Floors and a height of 100m.

It is always the same  pining. There is no difference in a 2 or a 32 Floor elevator system. The Hanging wire has three shield twisted pairs of wires .

With this pairs, you can do the multiprocessor communication,  the telephone connection, the encoder channels for the shaft encoder on the top of the car.

The Hanging Wire EHK 48 has a Cat-7 cable element inside.